China Top Ten Enterprise sa Fire Protection at Seguridad Industriya
» Superfine Dry Pulbos Fire Extinguishing Systems ABC estilo » Impulse Powder Fire Extinguisher for Car and Bus Engine Compartment
Magpataw ng Pulbos Fire Extinguisher para sa Kotse at Bus Engine Compartment
Super-fine ABC dry Chemical powder fire extinguisher for is a product with a long history, mainly apply in engine compartment of bus, car, truck, vessel etc,
it suppress fire quickly, just need 3 sa 5 segundo.
- Deskrip
- Mga Tampok at Aplikasyon
- Karagdagang Impormasyon
- Other Precautions
Impulse pulbos sunog extinguishers ay sobrang-pinong tuyo kemikal, ay pangunahin para sa engine paghahambing ng mga ships magdagdag ng mga sasakyan, baterya kompartment at retarder, naka-install sa kanilang mga lugar kung saan madaling makuha ang thermal runaway, Produktong ito ay may isang tiyak na pagkabigla pagtutol kakayahan, angkop para sa anumang masamang kapaligiran sa pagtatrabaho, maaaring ilabas ang klase A, B, C, E apoy.
Ang ganitong uri ng fire extinguisher ay maaaring awtomatikong kumpletuhin ang proseso mula sa paghahanap sa extinguishing ng isang sunog, ligtas at mahusay, madaling i-install at gamitin, lamang kailangan upang i-install ito sa itinalagang lokasyon sa sasakyan, kapag ang isang sunog break out sa makina, ang starter pagpupulong ay mabilis na ilipat ang apoy sa extinguishing device, at ang fire extinguishing device ay magsisimulang awtomatikong.
Maaari din itong maaktiba sa isang pre-install na simulang lumipat, buksan ang kahon ng pindutan, pindutin ang panloob na pulang plastic proteksiyon cover upang simulan ang pulbos fire extinguisher.
Mayroon itong 2 modong pagpapaaktibo, isa ay thermal aktibasyon, isa pang ay electric aktibasyon
THERMAL AKTIBASYON
Kapag makakuha ng isang bukas na apoy, o pagkasensya ng isang sunog temperatura ng 175°C, ang thermal wire ay i-igniit, at pagkatapos ay ang sunog extinguisher ay aktibo.
ELECTRIC AKTIBASYON
Matapos madahan ang temperatura ng sunog, ang tunog at ilaw alarma ay kikilos, Alarma manu-manong paglipat ay naka-install sa lugar ng pagmamaneho, sa kaso ng emergency, ang driver ay maaaring aktibahin ang fire extinguishing aparato mula sa cab, Mapagtanto ang epekto ng kontrol ng temperatura at electric control.
Produkto ay binubuo ng sobrang-pinong ABC tuyo pulbos, pabalat, diaphragm, inilaan socket, mga bahagi ng aktibasyon( thermal at electric), simulan ang control button at signal feedback device.
Ito ay ang mga sumusunod na parameter at data sheet:
- Modelo: FFX-ACD0.3/0.4/0.5
- Umiiral na ahente: 0.3, 0.4, 0.5 kilo.
- Sukatan: diameter 165*80mm(165*100mm).
- Tasa ng konsentrasyon: 127 gramo bawat kubiko metro.
- Volyum ng Proteksyon: saklaw mula sa 2 sa 5 kubiko metro.
- Umiiral na oras: mas mababa kaysa sa 5 segundo.
- Paglaban ng electric magsimula: 2.4 sa 5 Ω.
- Boltahe ng Operasyon: D at T 26-24 V.
- Aktibasyon kasalukuyang:mas mababa kaysa sa 0.5 A at higit pa sa 0.3 A.
- Kaligtasan kasalukuyang: ≤0.5 A.
- Modong Aktibasyon: electric at thermal wire.
- Pagtukoy alarma temperatura: 120±5°C.
- Thermal line activation temperatura: 175±10°C.
- Ambient temperatura: -40 sa +90°C.
- Modelo ng wire connector ng device: 282104-1.
- Kontrolin ang wire pagtutukoy modelo: NH-II.A-RVV-300/500-2×0.5-GA306.2-2007.
MGA TAMPOK
This product have features that similar to our Minisol Aerosol Fire Extinguisher, may mga:
- Small volume.
- Fully functional.
- Easy to install.
- Have function of manual start, automatic start and signal feedback.
- Comply with requirements of GB7258-2012 and international standards.
- Reliable quality and low price.
- Waterproof, moisture proof, freeze proof, and not require any pressurized cylinder to load.
- Good sealing and anti-vibration.
- Long service life, and in line with ISO vibration standard for vehicle fire extinguishers.
MGA APLIKASYON
It mainly used for the following fields:
- Vehicle engine compartment, such as bus, car.
- Vessel engine room.
- Battery compartment.
- Retarder.
- Generator room.
- Distribution cabinet.
- Charging pile.
- Cable trench and cable tunnel.
- Archive.
INSTRUCTIONS FOR USE AND MAINTENANCE
When the driver and occupant find and confirm the fire in the engine compartment, open the cover of the starter controller box which located in the cab, Press the red start button hardly to start the fire extinguisher to put out the fire(attention: There are two miniature buttons under the red launch button board, Only by pressing at the same time, the fire extinguishing device can be activated, otherwise the fire extinguishing device will not be activated); Do not open engine compartment doors and covers before and after extinguishing a fire, Because the fire extinguishing effect is better in closed space.
Drivers and passengers should inspect the fire extinguisher regularly, if the aluminum foil at the nozzle of the fire extinguishing device is damaged, the screws of the fire extinguishing device are loose, and the wiring is disconnected, it should be replaced and repaired in time.
Avoid open flame and high temperature operation to avoid mis-operation; when disassembling and assembling the fire extinguishing device, please ask the professional person who know about this device.
TRANSPORT AND STORAGE
- Handle with care when transporting.
- Throwing is strictly prohibited.
- Prevent collision.
- Avoid exposure to sunlight and rain.
- Storage warehouses require ventilation, dryness and cleanliness.
- The height should not exceed 6 layers.
EXPIRATION DATE
The warranty period for this fire extinguishing device is 2 taon, and life span is 5 sa 10 taon, after the expiration date, please contact your local dealer or manufacturer, we will replace at a discounted price.
AFTER SALES SERVICE
Our company has an after-sales service department, and has established quality and after-sales tracking service files, Free replacement if the product has quality problems.
INSTALLATION PRECAUTIONS
- Open flame and with electricity must be avoided during installation.
- This device must use the nominal working pressure and current.
- Regularly check the fire extinguishing device. If the fire extinguishing device is damaged or has been sprayed, the fire extinguishing device must be replaced in time.
Temperature control(thermal cord 175℃) installation precautions
The jet of the fire extinguisher needs to be aimed at the engine and fixed firmly, Thermal wires are routed around the engine, The thermal line and the fire extinguisher should be 15 cm away from the engine.
Electric control installation precautions
- Should be power off to operate.
- Open flame work is prohibited.
- The thermal line should be more than 15 cm away from the high temperature part of the engine, Otherwise, the temperature is high in summer, and it is easy to start.
- Please operate according to the wiring diagram of the fire extinguishing device, Otherwise, the wrong line may be connected.
- During the debugging process, please use a multi-meter to confirm the electric start terminal and feedback terminal; do the wire connection job after confirming it is correct, Please read the installation manual carefully before wiring.
Form ng Pagtatanong ( kami ay bumalik sa iyo sa lalong madaling panahon )
Siguro gusto mo rin
Kopyahin2022© | Jiangxi Kamalayan Fire Teknolohiya Co, Ltd ang lahat ng karapatan nakalaan